On-site garage equipment repairs across the South West
A dead lift is not one problem, it is every job booked into that bay. The same goes for a compressor that has stopped, a brake tester that will not read or an MOT bay that cannot be used until something is signed off. The repair is rarely the expensive part — the downtime is.
Our engineers work across Bristol and the South West with vans stocked for the equipment we know we are going to meet, because most of it is equipment we supplied and fitted in the first place. That is the practical advantage of buying from a dealer that still has its own workshop: the person who arrives has usually seen the machine before.
Where we can, it is fixed on the visit. Where a part has to be ordered, we will tell you what it is and when it is coming rather than leave you guessing and rearranging bookings around a maybe.
The same engineers install and commission new equipment, which is why installation is not a separate conversation with a separate company. A lift that we fitted, we know the site of.
- Bristol and the South West
- Our own engineers, not subcontractors
- Vans stocked for the common failures
- Installation and commissioning too
Ranges we do this for
Air Compressors
Piston, screw and portable, from 3hp workshop units to tandem installations.
37 products
Vehicle Lifts
Two-post, four-post and baseless lifts from two to six tonnes.
15 products
Tyre Equipment
Tyre changers and wheel balancers, supplied, installed and trained on site.
5 products
MOT Bays
Class 4 and Class 7 ATL bays, gas and smoke analysers and ancillary packs.
7 products
Wheel Aligners
Hofmann Megalign and Megaline alignment systems.
3 productsOn-site Repairs — questions we get asked
Do you cover my area?
Bristol and the South West. Ring with a postcode and we will tell you straight away.
Are they your own engineers?
Yes, not subcontractors. Most of them have seen the equipment before because we fitted it.
Will it be fixed on the visit?
Where the part is on the van, yes. Where something has to be ordered we will tell you what and when rather than leave it open.
Do you install new equipment on site as well?
Yes — installation and commissioning are done by the same engineers who service it afterwards.
Our other service lines
Every one of these runs out of the Kingsland Road workshop, on equipment we supplied and on equipment we did not.
Calibration Services
Torque wrenches and equipment calibrated and certificated.
Garage Equipment Repairs
Repairs to lifts, compressors and workshop plant.
Hydraulic Repairs
Rams, pumps and hydraulic systems rebuilt.
On-site Repairs
Engineers to your workshop, so the bay is not out for long.
Tool Repairs
Air tools stripped, repaired and returned.
Warranty Repairs
Approved warranty work on the makes we supply.
Book in on-site repairs
Tell us the bay, the vehicles and what it has to lift, weigh or measure, and we will tell you what fits — and what it will cost installed, trained and certificated.
If something has stopped, ring. Breakdowns are not a form.
- Phone 0117 955 6133
- Email sales@pomphrey.com
- Open Monday–Friday, 8am–5pm
Tell us what the workshop needs.
Send an enquiry 0117 955 6133