Wheel Aligners at Pomphrey
Hofmann alignment systems, including the Megalign and Megaline ranges, for workshops taking alignment seriously enough to charge for it.
Alignment is one of the few pieces of workshop equipment that pays for itself out of work you are already turning away. A car that pulls, wears a shoulder off a tyre or has been through a pothole is an alignment job, and without the equipment it goes down the road. With it, every set of tyres you fit is a check you can charge for.
The equipment only works if it is installed against a properly prepared surface, and on a four-post lift or an alignment pit rather than an afterthought, which is the part most people underestimate. We look at the bay before we quote, install and commission the system, and calibrate and service it afterwards.
Wheel Aligners we supply in Bristol
Figures as they appear in our catalogue. Prices are quoted against the job — the machine, the installation and the training — so ring 0117 955 6133 or send the details.
Photographs are from our own catalogue and are a guide to the type of equipment — ring us to confirm the exact model before you order.
What we do for this equipment
The same company that supplies it keeps it working. These service lines apply to everything on this page.
Wheel Aligners — questions we get asked
Is alignment equipment worth it for a small workshop?
It pays for itself out of work you are already turning away. Every set of tyres you fit is a check you can charge for, and cars that pull or wear a shoulder off a tyre currently go down the road.
What does it need to be installed on?
A properly prepared, level surface, and a four-post lift or an alignment pit rather than an afterthought. That is the part most people underestimate, so we look at the bay before quoting.
Does it need calibrating?
Yes, and it stays on our service run afterwards along with the rest of the equipment we supply.
Can it be used on commercial vehicles?
Depends on the system and the lift under it. Tell us what comes through the door and we will tell you what will cover it.
The rest of the catalogue
Air Compressors
Piston, screw and portable, from 3hp workshop units to tandem installations.
37 products
Air Tools
Impact wrenches, drills, ratchets, shears and sanders, mostly Chicago Pneumatic.
35 products
Jacks & Hydraulics
Trolley and bottle jacks, transmission jacks, axle stands, presses and cranes.
25 products
Vehicle Lifts
Two-post, four-post and baseless lifts from two to six tonnes.
15 products
Torque Wrenches
Norbar Pro, Industrial and Nortorque, with calibration in our own workshop.
14 products
Tyre Equipment
Tyre changers and wheel balancers, supplied, installed and trained on site.
5 products
MOT Bays
Class 4 and Class 7 ATL bays, gas and smoke analysers and ancillary packs.
7 products
Lubrication
SAMOA oil and grease pumps, reels and dispensing equipment.
7 products
Heaters
Propane and paraffin space heaters for the workshop floor.
5 products
Battery Chargers
Starter chargers and road-start units.
3 products
Welders
MIG welding plant and protective equipment.
2 productsTell us what the workshop needs
Tell us the bay, the vehicles and what it has to lift, weigh or measure, and we will tell you what fits — and what it will cost installed, trained and certificated.
If something has stopped, ring. Breakdowns are not a form.
- Phone 0117 955 6133
- Email sales@pomphrey.com
- Open Monday–Friday, 8am–5pm
Tell us what the workshop needs.
Send an enquiry 0117 955 6133